Chapter 17, Annex AD TOP WING ASSEMBLY LINE

Director Cadets 3, 2007, Ottawa, ON: Department of National Defence

Figure AD-1  Top Wing Assembly Line

For each aluminum model biplane to be constructed:

1.Combine cardboard parts TWC, TWAS and three pre-bent aluminum panels (dimensions of 3-5/8 inch by 8-1/8 inch) to form top wing (all from stock).

2.Insert panels (dimensions of 2-5/8 inch by 8-1/8 inch) under wing (from stock).

3.Staple top wing (ten staples).

4.Apply Wing Bolt Hole Placement Template (WBHPT) to top of top wing and with a push-pin, make eight holes for bolts in the top wing (top wing to stock).

D. P. Mathis, Building the B.C. Air Originals Biplane, B.C. Air Originals (p. 12)

Figure AD-2  Wing Bolt Hole Placement Template (WBHPT)